Sandvik Cyclones and Assorted Mining Machinery (10 Pieces)

New, unused surplus. All crates are in good order. They are somewhat dust-covered. Not all still had PL, or identification stapled to the boxes.

Box I: In good order. Had several Dints identification marks on it and contained a bulk of items on the packing list We viewed the following items as listed on the packing list

Not listed on the PL was a single flange guide. Not identified that was on the PL were 9 bearing brushes. These may have been in the box at a bottom layer but whilst we removed most top layers, we did not want to disturb the full integrity of the packing. All items viewed appeared to be in the condition in which they were packed-i.e. in apparent good order. Under separate cover will send a mail with various pictures of what in this box.

Box 2: Listed on the box as a “compressor assembly”. Gear had pushed through the side of the box but no apparent effect on gear or the compressor. Pictures per separate mail.

Box 3: This box arrived without a lid. Contained one item. Docs inside the box and one label on the outside identified the unit as a “primary cyclone”. Item appears as loaded-other than light dust covering in good order.

Box 4: Contained 1 item identified as “primary cyclone/ Plastic covered. In apparent good order. Pallet 5- this had two long orange painted cylinders. No paperwork attached. Partial plastic wrapping was Sandvik branded. Item appears in good order. We do not have sufficient knowledge of what this is. On main PL, in addition to 9 bearing brushes as advised above, there is mention of 19 “shaft”. We identified 9 in box 1 (as per individual PL for that box), but not 19. The additional 10 were not in any of the other boxes, but maybe in some, we have yet to receive.