This Drilling Motor is no longer needed for the company's operations and is being sold to recover funds.
GE 1500 hp ATEX certified AC drilling motor with blower
Horizontal, splash-proof fully guarded (IP-44), blower ventilated.
Maximum Continuous hp:
1500 hp, 8750 ft. lbs., 1360 amps, 600 vac, and 900 - 1200 rpm
Intermittent duty cycle:
1830 hp, 12000 ft. lbs., 1740 amps, 600 vac, and 800 rpm (60 sec. on – 30 sec. off)
Maximum RPM: 3000
Temperature rating: 1100C rise at 450C ambient
- 6 pole stator with form wound windings.
- Copper alloy rotor bars and end rings.
- Class H insulation, robotically taped, Mica-Kapton system.
- Insulated non-drive end bearing. Drive end bearing designed for Axial loads.
- Single shaft extension with hub. High strength 4340 alloy steel shaft.
- Stainless steel main terminal box is IP56 with bus bar connections for main cable terminations. Terminal points for RTD & pressure sensor connections. Terminal box can be specified to be mounted on left “A” side or right “B” side of motor as viewed from non-drive end of motor.
- (6) RTD’s, 100 ohm platinum, two per phase embedded in star slots.
- Pressure sensor.
- Blower assembly: 20 hp, 460 vac, 60 hz., EExde blower motor, meets or exceeds 3900 scfm of required ventilation air.
- Drill motor is ATEX certified EExe II T3 by SIRA.
- Space heater: 100 watt EEx. EEx termination box.
- Motor is “CE” marked for use on “CE” marked AC drives.
- Motor enclosure is IP44.
- ABS certified shaft.
- Motor has same mounting feet dimensions and shaft height as the GE 752 motor.
- Approximate weight: 8500 lb., 3859 kg.