ATTENTION: This item is no longer available.
VIEW AVAILABLE ITEMS
California, United States
This conveyer belt system must be sold in order to recover funds. Many of the parts look brand new.
30 inch wide (15" long & 6" high rolled up and flattened) roller belt (unknown length too long to roll out in trl & trl's is 53' long)
A lrg roll 24" long, 21 1/2" high, 30" wide rolled and flattened.
Another roll was 20" long and 8" high 30 wide.
A Hytrol 90-degree curved roller system. End to end it is 125" & inside length of the curve from end to end in a straight matter at 77".
The roller belt system is 36" wide and the rollers themselves are 33".
The adj. found 1 # on the system MT7B.
There is a stack of racks & supports palletized and shrinked.
There appear to be a total of 18 new green racks or supports.
There is 11 boxes 36" wide, 5 3/8" high and 10' long, one side exposed so you can see the rollers in them.
There is a shorter box on top of that with a electric motor attached. Looks like a lrg tension motor to run the chain.
It had little identification other than Rockwell Automation.
Also another motor that looks smaller 45" long, RPM 1725; volts 208-230; amps 2.9-2.6; HZ 60; SF 1.15.
Manufacturer is Reliance System.
Also found brackets that were 4" wide and 12" long, also a guard to keep the rollers from sliding off.